|
|
|
Transformers |
TA125 Series
Minitype Precision AC Current Transformers
|
1.Features:
- Being able to be directly welded on PCB;
- Fully encapsulated, strong mechanical and environmental endurance, strong
dielectric strength and beautiful appearance.
2.Conditions of usage:
- Circumstance temperature: -55...+85°C;
- Relative humid <90% при 40°C;
- Atmospheric pressure: 860~1060mbar (650~800mmHg approximately);
3.Range of working Frequency: 20Hz~1kHz
4.Insulation Rating: Class F (155°C).
5.Safety features:
- Insulation resistance: >1000MOm in normal condition;
- Insulation withstand voltages: 6000V 50Hz/1min;
- Fire proof: accord with the grade of UL94-Vo
6.Outline Drawing, Installation Dimention and Coil Diagram
7.Typical Usages and Technical Parameters.
The sampling voltage is obtained directly by using a resistor(as shown in the
right figure).
The parameters are listed in table below.
Model |
Rated
Input
current |
Rated
Output
current |
Rated
sampling
resistance |
Rated
sampling
voltage |
Phase
Shift |
Non
Linearity |
Linear
Range |
Withstand
Voltage |
TA125-1 |
50A |
50mA |
100 Om |
5V |
<30` |
<1% |
>2.5
times
of
rated
value |
>6kV |
TA125-2 |
50A |
25mA |
400 Om |
10V |
TA125-3 |
50A |
20mA |
750 Om |
15V |
2
times
of
rated
value |
8.Attention:
- The primary of the current transformer must be connected in series with the
loop of the measured current. The secondary should operate in a mode of near short
circuit.
- The secondary of the current transformer is not allowed to be open circuit,
Do Not install any fuse.
|
|
|
|
|
- Цены, опубликованные в Магазине, могут не являться окончательными и предназначены только для предварительного ознакомления.
Информацию о наличии товаров и свежих ценах уточняйте у менеджеров, они устанавливают окончательные цены при оформлении заказа в зависимости от количества товара и истории клиента. Или нажмите ссылку:
sales@dart.ru
- Представленная техническая информация и размеры на чертежах, опубликованных на сайте, носят справочный характер и не предназначены для использования в конструкторской документации без согласования с нами.
Для получения актуализированной технической информации нажмите ссылку:
alex@dart.ru
- Возможность поставки товаров, где не указан код товара, уточняйте у наших менеджеров.
- Перед закладкой компонентов в серийные изделия необходимо запрашивать образцы!
|
|
|
|
|